Wood & steel frame
Wrought iron
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Edgewood, FL
Gate installation in Edgewood means building for humidity, afternoon storms, and older single-family lots where a gate has to close reliably for years, not just for the first season. Most of the driveway gates we install here are aluminum or steel-frame gates sized for private residential drives, often replacing rusted wrought-iron gates that have swelled and seized from decades of lake-adjacent air. Arroyo Gate Repair has served Edgewood since 2013, and we quote every installation with a fixed written price before any work begins. Call (877) 851-6955 for a free on-site measure and estimate.
Why Edgewood Homes Are Different
Edgewood is a small residential enclave surrounded by Orlando and tucked near the Conway chain of lakes. That geography changes how gates fail and how they should be built. The lots are generous and fenced, and much of the housing stock is mid-century block and stucco with newer custom builds mixed in. Wrought-iron, aluminum, and wood driveway gates are common, along with pool-area gates that see constant moisture. The lake-adjacent lots hold standing water at gate posts after afternoon storms, so bottom hinges and operator mounts corrode faster than homeowners expect. Intense UV breaks down powder coating and wood sealers year-round, and the summer rain cycle means photo-eye sensors and control boards sit in damp air for months at a time. A gate that would survive ten years in a drier climate often needs hinge replacement and operator work in half that time here. When we install a new gate in Edgewood, we set posts with drainage in mind and choose hardware rated for constant humidity, because the standard off-the-shelf hinge is the first thing to fail on a Conway-chain lot.
Styles & brands we work with
Our Main Edgewood Services
Most Edgewood homeowners call us for one of two reasons: a gate that no longer opens or closes smoothly, or an automated system that has stopped responding entirely. Both are covered by dedicated Edgewood service pages.
Gate Repair in Edgewood
Mechanical gate repair in Edgewood usually comes down to hinges, posts, and sagging frames. Wrought-iron gates near the lakes rust from the bottom up, and wood gates swell with the humidity until the latch no longer lines up. We straighten frames, replace seized hinges, reset posts, and rebuild latch points so the gate swings cleanly and closes without lifting. We work on LiftMaster, FAAC, BFT, and Linear hardware, but the mechanical side matters just as much as the operator. If your gate drags on the driveway or the hinges groan, the full breakdown is on Gate Repair in Edgewood.
Electric Gate Repair in Edgewood
Automated gates in Edgewood fail in predictable ways: photo-eye sensors fog or misalign after storms, control boards corrode from trapped moisture, and motors burn out from pushing a gate that humidity has made heavier. We diagnose by system logic, not trial and error, so you aren’t paying for parts you didn’t need. That means testing the motor, board, sensors, and access hardware as one integrated system before recommending a fix. If your opener runs but the gate won’t move, or the gate reverses for no reason, see Electric Gate Repair in Edgewood for the specifics.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Gate Installation in Edgewood
A new gate in Edgewood has to be built for the climate, not just bolted to old posts and called done. Most installations we do here replace gates on mid-century and custom single-family lots where the original iron or wood gate has rusted through, rotted, or sagged beyond repair. We build for the humidity and standing water that come with lots near the Conway chain, and we set posts and hardware so the gate swings true five years from now, not just on install day. Every gate installation includes a free on-site measure and a written price agreed before any work begins. For the full scope of what we install, see Gate Installation.
Automatic Gate Installation
Signs you need it
You’re opening and closing the gate by hand because the old operator is dead, or you want keypad or remote access on a gate that was never automated.
What it costs in Edgewood
Plan on $2,200 – $7,500 for a complete automatic gate system depending on gate length, operator type, and power access.
How we do it
We measure the gate leaf and post structure, confirm power and access requirements, mount the operator, wire the control board and safety sensors, and test full open-close cycles.
Driveway Gate Installation
Signs you need it
Your existing driveway gate is rusted, sagging, or dragging on the concrete, and repeated latch repairs haven’t held.
What it costs in Edgewood
A new residential driveway gate in Edgewood typically runs $1,800 – $5,500, with aluminum at the lower end and steel or custom iron at the upper.
How we do it
We remove the old gate, set or repair posts for proper drainage, hang the new gate with sealed bearings, and adjust travel and stops for clean latching.
What Gate Installation Costs in Edgewood
| Item | Typical range in Edgewood |
|---|---|
| Residential driveway gate | $1,800 – $5,500 |
| Automatic gate system | $2,200 – $7,500 |
| Operator, board, edge sensors | $900 – $1,400 |
Can you install a gate on an existing driveway in Edgewood?
Yes. We install on existing concrete drives, pavers, or gravel without tearing out the driveway. The key is setting posts deep enough to handle the weight and the standing water common on lake-adjacent lots. Call (877) 851-6955 for a free measure.
Does Gate Installation in Edgewood include the opener and safety sensors?
When you choose an automatic gate, yes. The quote includes the operator, control board, photo-eye sensors, and edge protection so the gate meets safety requirements. We quote the complete system up front, not piecemeal.
Brands We Service in Edgewood
Arroyo Gate Repair is a multi-brand gate specialist. We service LiftMaster, FAAC, BFT, and Linear systems regularly in Edgewood, and we carry common boards, remotes, and sensor parts so most repairs don’t wait on a distributor shipment. Visit our brands to see the full lineup.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Edgewood, FL
| Service | Typical range in Edgewood |
|---|---|
| Gate repair, general | $150 – $600 |
| Electric gate repair | $180 – $480 |
| Control board replacement | $350 – $950 |
| Hinge or caster replacement | $150 – $400 |
| Gate opener installation | $900 – $1,400 |
| Residential driveway gate installation | $1,800 – $5,500 |
| Automatic gate system installation | $2,200 – $7,500 |
| Sliding gate installation | $2,500 – $6,500 |
The biggest cost drivers in Edgewood are post replacement after years of standing water and gate weight on older iron gates that were never built for automated operation. Whatever the job, our price is quoted and agreed before any work starts, so there are no surprises at the end.
Neighborhoods We Serve in Edgewood
Edgewood is compact, and we cover the entire city and the surrounding Orlando neighborhoods that share its housing stock. If you’re on a lake-adjacent lot or in an older block-stucco section, the repair profile is the same: humidity-driven hinge and operator failures. We’re usually working in the Edgewood area within the same week for standard repairs.
- Edgewood city limits
- Conway chain-lake adjacent lots
- Mid-century block and stucco sections
- Custom-build subdivisions
Service Area – Cities Near Edgewood
We also handle gate repair and installation in the communities immediately around Edgewood. If you’re in Belle Isle, FL, Pine Castle, FL, Sky Lake, FL, or Holden Heights, FL, the same team covers your area, and the gate failures are nearly identical: humidity, storm water, and aging hardware.
Serving Edgewood, FL — Our Local Coverage Area
We’re based in the Edgewood area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Edgewood
Most Edgewood repair calls are scheduled within a few days, and we prioritize genuinely stuck gates where the driveway is blocked. Emergency dispatch depends on the day and workload, but we’ll tell you the next available window when you call (877) 851-6955.
Edgewood is largely single-family residential without widespread HOA gate restrictions, but some custom-build subdivisions have design standards. We’ll flag anything that looks like it needs review before quoting, so you aren’t dealing with it after the gate is hung.
We do both. Arroyo Gate Repair is a gate-only operation that covers the mechanical gate, the electric operator, the control board, sensors, and access hardware. That full-cycle scope means one crew, one schedule, and one warranty conversation instead of chasing two vendors.
If your gate is stuck, sagging, or the opener stopped listening, call Arroyo Gate Repair at (877) 851-6955 for a free estimate. We’ve served Edgewood since 2013, and we diagnose by system logic, not guesswork.
What happens when you call
- 1A real person answersNo phone trees — talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Edgewood Customers Say
"Solar panel on our remote gate wasn't keeping the battery up through the winter. He repositioned it, replaced the battery, and explained the math on why the old placement was never going to work."
— Rohan Reddy"Photo eye was misaligned so the gate refused to close after dark. Ten minute fix. He also cleaned the lens and pointed out that the sprinkler head was spraying it every morning, which is why it kept happening."
— Michelle Anderson"We had a hydraulic arm leaking fluid onto the driveway. Replaced, cleaned up the stain as best he could, and it's been dry for months."
— Yolanda Hernandez