Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
See the difference
Before
After
Before
After
Before
AfterHow Much Does Gate Repair Cost in Orlando?
Gate repair in Orlando typically runs $150 to $650 for most residential fixes, with automated and commercial systems landing higher at $250 to $1,200+ depending on the operator and what failed. A simple hinge, latch, or sensor adjustment sits at the low end; a control board replacement or motor swap on a commercial operator pushes toward the top. Most of the swing, slide, and driveway gate calls we run in Orlando fall in the $200 to $450 band once we’ve diagnosed the actual fault.
We’re Arroyo Gate Repair, a gate-only operation. We don’t do fencing, we don’t do garage doors, and we don’t moonlight as handymen. That focus matters when your automatic gate stops opening and you need Gate Repair in Orlando that diagnoses the system correctly the first time instead of swapping parts by guesswork.
Key Takeaways
- Residential gate repair in Orlando: $150 – $650 for most jobs.
- Electric and automated gate repair: $250 – $1,200+, driven by the operator brand and the failed component.
- Diagnostic service call: $75 – $150, often credited toward the repair.
- Sensor and safety-loop problems are the most common automated gate failure we see, and usually the cheapest to fix.
- Repair almost always beats replacement unless the gate frame or operator is at the end of its life.
Gate Repair Cost Breakdown (2026)
Here’s what the line items actually cost in the Orlando market this year. These are real ranges we work inside, not placeholders. Your exact number depends on the gate type, the operator, and how accessible the mechanism is.
| Repair item | Typical cost range | Notes |
|---|---|---|
| Diagnostic service call | $75 – $150 | Usually credited toward the repair if you move forward same visit |
| Hinge, roller, or track repair | $100 – $250 | Common on manual swing and slide gates |
| Latch, handle, or lock replacement | $90 – $220 | Access hardware on both manual and automated gates |
| Gate alignment and sag correction | $150 – $400 | Sagging gates often drag the operator and cause secondary failures |
| Safety sensor / photo-eye replacement | $150 – $350 | The single most common automated gate call |
| Control board replacement | $250 – $650 | Brand-dependent; DoorKing and FAAC boards sit higher |
| Gate operator motor replacement | $400 – $1,200+ | Residential openers at the low end, commercial slide operators at the top |
| Loop detector or access-control repair | $200 – $500 | Commercial properties, HOAs, and gated communities |
| Full operator replacement (residential) | $1,200 – $2,800 | When the motor and board are both gone |
What pushes a bill up: the operator brand (commercial-grade systems like FAAC, BFT, and DoorKing cost more in parts than a Mighty Mule or Ghost Controls residential opener), whether the gate is a swing or slide unit, how buried the wiring and control box are, and whether the failure is mechanical or electrical. What pulls it down: catching the problem early, having the brand clearly identified before we arrive, and fixing a $150 sensor instead of letting a dragging gate wear out a $600 motor. A gate that’s out of alignment for a month will eat an operator. Fix the alignment first.
What Affects Gate Repair Pricing in Orlando
Orlando has its own set of conditions that show up in repair costs here. None of it is random; it’s the climate, the housing stock, and the mix of residential and commercial gates across the metro.
- The operator brand. A residential Mighty Mule or Ghost Controls opener is a modest parts bill. A commercial DoorKing slide operator or a FAAC barrier arm carries professional-grade pricing. We service nine major brands, so we’re not marking up a part we don’t stock because we’re unfamiliar with the system.
- Humidity and afternoon storms. Central Florida’s wet season punishes control boxes, exposed wiring, and photo-eye lenses. We see far more sensor faults and corroded control-board connections in the summer months than in dry stretches. Lenses fog, water finds its way into enclosures, and a gate that worked all spring starts acting erratically in June.
- Sandy soil and settling. In newer subdivisions across the metro, gate posts settle and gates go out of alignment. A gate that drags on the ground puts strain on the operator motor and hinges. Fixing the alignment early is far cheaper than replacing the motor later.
- HOA and gated-community access systems. Entry systems with loop detectors, keypads, vehicle sensors, and intercoms add components that a simple driveway gate doesn’t have. Each one is a potential failure point and a line item.
- Access and site conditions. A gate mounted in an open driveway is quick to work on. A commercial slide gate boxed in behind landscaping, or a control panel in a cramped HOA equipment room, adds labor time.
- Swing vs. slide vs. barrier. Swing gates and slide gates have different operators and hardware, and commercial barrier arms are a different system entirely. The gate type sets the baseline before we diagnose anything.
If you’re comparing a repair quote against a replacement quote, the honest answer usually comes down to the operator’s age and the gate frame. We’d rather tell you a repair is the right call than sell you a new system you don’t need.
How to Save on Gate Repair
Gate repair isn’t the place to shop purely on price; a cheap fix that fails in three months costs more than the right one. But there are real ways to keep the bill down in Orlando.
- Get a diagnostic before approving parts. A trial-and-error parts swap is how bills balloon. A proper diagnosis on the actual system logic means fewer replaced components and faster resolution. That’s the difference between a $200 sensor fix and a $600 board-and-motor guess.
- Fix alignment and drag early. A gate that scrapes the ground or hangs on one hinge is grinding your operator every cycle. Correcting it now is far cheaper than a motor replacement later.
- Clear the gate path. Debris, overgrown landscaping, and dirt in the track cause gates to stall, which trips sensors and burns out motors. A few minutes of clearing ahead of a service call can prevent the call entirely.
- Keep the control box sealed and dry. This matters in Orlando’s wet season. A well-sealed enclosure keeps water off the board and saves you a control-board replacement.
- Ask about the estimate up front. We offer free estimates. Call (877) 851-6955 and get a real number instead of a range over the phone that shifts when the tech arrives. Honest, upfront pricing is part of how we operate.
One more: know your brand. If you can tell us the make and model of your operator before we arrive, we come prepared with the right diagnostics and often the right part. That shortens the visit and the labor line.
FAQs – Gate Repair Cost
How much does it cost to repair a gate in Orlando?
Most residential gate repairs in Orlando cost between $150 and $650, and automated gate repairs run $250 to $1,200+ depending on the operator and the failed component. A simple hinge or latch fix sits at the low end; a motor or control-board replacement pushes toward the top. Call (877) 851-6955 for an exact quote on your gate; estimates are free.
How much does electric gate repair cost in Orlando?
Electric and automated gate repair typically runs $250 to $1,200+, with the price driven mostly by the operator brand and which component failed. Sensor and photo-eye replacements are the cheapest common fix at $150 – $350, while a motor replacement on a commercial operator can exceed $1,000. Because we work on nine major brands including FAAC, BFT, DoorKing, and LiftMaster, we diagnose the actual electrical fault rather than guessing. Call (877) 851-6955 for a free estimate.
Is it cheaper to repair or replace a gate?
Repair is cheaper in most cases, often by a wide margin – a fix in the $200 – $450 range versus $1,200 – $2,800 for a full residential operator replacement. Replacement only makes financial sense when the operator is at the end of its life or the gate frame itself is failing. We’ll give you a straight answer rather than pushing a replacement you don’t need. Call (877) 851-6955 and we’ll tell you which side of that line your gate is on.
Why does my automatic gate keep opening and closing on its own?
A gate that cycles on its own is almost always a misaligned or dirty safety sensor, or a loop-detector fault – both fixable in the $150 – $500 range. It’s the most common automated gate problem we see in Orlando, especially after heavy rain pushes debris onto the photo-eye lenses. Don’t ignore it; a gate that opens randomly is a security gap. Call (877) 851-6955 and we’ll get it looked at.
Do you charge for the estimate?
No – estimates are free. A diagnostic service call (when we need to trace the fault on-site) typically runs $75 – $150 and is usually credited toward the repair if you move forward. You get a clear number before we touch the gate. Call (877) 851-6955 to get started.
Why Choose a Gate-Only Specialist for the Repair
General handymen will take a gate call and guess at it. Automated gates are a system: motor, control board, sensors, safety loops, and access hardware all talk to each other. A part-swapping approach on an electric gate gets expensive fast because you’re paying for parts you didn’t need. Our technicians diagnose by system logic, which means fewer unnecessary replacements and a repair that holds.
We service nine major operators – LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule – spanning entry-level residential openers up to professional commercial systems. That range covers most driveway gates, HOA entries, and commercial access points across Orlando. And because we handle repair and installation under one roof, there’s no hand-off to a third party when a repair turns into a replacement. From driveway gates to commercial access systems, it’s a gate-only focus you won’t get from a generalist. If you’d like to see how we approach repairs generally, our home page lays out what we do.
When a gate is stuck open or a commercial entry won’t secure, you don’t want a callback queue. You want a technician who recognizes the system on sight. Call (877) 851-6955 for a free estimate and get a real number on your Orlando gate repair.
Pricing reflects the Orlando market as of 2026. Arroyo Gate Repair offers free estimates – call (877) 851-6955.
What Our Customers Say
"The loop detector under the driveway had failed and residents were stuck holding the button. He traced it, found the break, and had the exit loop reading cars again the same visit."
— Chris Lawson"Solar panel on our remote gate wasn't keeping the battery up through the winter. He repositioned it, replaced the battery, and explained the math on why the old placement was never going to work."
— Rohan Reddy"Photo eye was misaligned so the gate refused to close after dark. Ten minute fix. He also cleaned the lens and pointed out that the sprinkler head was spraying it every morning, which is why it kept happening."
— Michelle Anderson